Product name: Fluorescent powder coatings

General introduction: 
This powder coating product is made by adding special fluorescent pigment on the basis of general coating, with special bright red, orange, yellow, green and other colors, used for fitness, leisure, sports equipment, fire equipment, road signs and so on.

Product series: 
Can provide indoor, outdoor different gloss products.

Physical properties: 
Specific gravity(g/cm³, 25℃): 1.0-1.4
Particle size distribution: 100 % less than 100 micron (It can be adjusted according to the special requirements of coating)

Construction conditions
Pretreatment: Different pretreatment for different substrates (phosphating treatment, sand blasting treatment, shot peening treatment)
Curing mode: manual or automatic static gun construction
Curing conditions: according to the different varieties of products, please refer to the product with the attached technical specifications.

 

Coating performance:
 

 

Notes:
1.The above tests used 0.8mm thick cold-rolled steel plates with a coating thickness of 50-70 microns.
2.The performance index of the above coating may change with the change of color and gloss.

Average coverage:
8-9 sq.m./kg; film thickness 70 microns (based on 100% powder coating utilization rate) 

Packing and transportation: 
The cartons are lined with polyethylene bags, net weight is 20KG; Non-hazardous materials can be transported in various ways, but only to avoid direct sunlight, moisture and heat, and avoid contact with chemical substances.

Storage condition: 
Store in a ventilated, dry and clean room at 30℃, not close to the fire source, central heating and avoid direct sunlight. It is strictly prohibited to pile up in the open. Under this condition, the powder can be stored for 6 months. After the storage life can be re-examined, if the results meet the requirements, can still be used. All containers must be repackaged and repackaged after use.

Notes:
All powders are irritating to the respiratory system, so avoid inhaling powder and steam from curing. Try to avoid direct contact between skin and powder coating. Wash skin with water and soap when contact is necessary. If eye contact occurs, wash skin immediately with clean water and seek medical attention immediately. Dust layer and powder particle deposition should be avoided on the surface and dead corner. Tiny organic particles will ignite and cause explosion under static electricity. All equipment should be grounded, and construction personnel should wear anti-static shoes to keep the ground to prevent static electricity.